Get your Scalextric IRL car to handle by stacking magnets.
  This is all you will need.  A Phillips  screwdriver and 1 Fly rectangular magnet. Total cost about $31.00
2.JPG (135992 bytes) First take the body off of the chassis. 
3.JPG (142672 bytes) Second pop the motor out.
4.JPG (161755 bytes) Third place the Fly magnet in the center of the stock magnet.
5.JPG (87019 bytes) This is the tricky part.  You will need to trim the plastic tab around the right screw hole. Only remove a little at a time.  You don't want to take off too much.  
6.JPG (110799 bytes) Once that is all done, replace the body on the chassis.  Screw it down and go racing.  Just don't tell your friends this trick until after you have beaten them a few times.  Enjoy!!
   

Hit Counter